create_ap:tldr:93bb4
create_ap: Choose a different Wi-Fi adapter driver.
$ create_ap --driver ${wifi_adapter} ${wlan0} ${eth0} ${access_point_ssid} ${passphrase}
try on your machine
This command creates an Access Point (AP) using the create_ap utility. Here is an explanation of each argument:
--driver ${wifi_adapter}: This specifies the driver to be used for the WiFi adapter. The${wifi_adapter}variable should be replaced with the name of the driver for your specific WiFi adapter.${wlan0}: This is the name of the physical wireless interface that will be used to create the AP. Replace${wlan0}with the actual name of the interface.${eth0}: This is the name of the Ethernet interface that will be used to provide internet connectivity to the AP. Replace${eth0}with the actual name of the interface.${access_point_ssid}: This specifies the desired SSID (Service Set Identifier) or the name of the AP that will be created. Replace${access_point_ssid}with the desired name for your Access Point.${passphrase}: This is the passphrase or password that will be required to connect to the Access Point. Replace${passphrase}with the desired password.
By running this command with the appropriate values, you can create an Access Point using your WiFi adapter and provide internet access using the specified Ethernet interface.
This explanation was created by an AI. In most cases those are correct. But please always be careful and
never run a command you are not sure if it is safe.