dvc-config:tldr:af024
dvc-config: Set the project's default remote.
$ dvc config core.remote ${remote_name}
try on your machine
The command "dvc config core.remote ${remote_name}" is used to configure the remote storage location in the DVC (Data Version Control) configuration.
Here's a breakdown of the components in the command:
- "dvc" refers to the DVC command-line tool.
- "config" command is used to interact with the DVC configuration settings.
- "core.remote" is a configuration property that specifies the remote storage location.
- "${remote_name}" is a placeholder for the name of the remote storage location. You need to replace it with the actual name you want to give to the remote.
When you run this command, it sets the value of the "core.remote" configuration property to the specified remote name. This allows DVC to know where to store and retrieve data from when you perform operations such as pushing or pulling data from a remote storage location.
This explanation was created by an AI. In most cases those are correct. But please always be careful and
never run a command you are not sure if it is safe.