spi:tldr:082e9

spi: Purge the local package and slackbuild caches.

$ spi --clean

try on your machine

The command "spi --clean" is used to clean up the SPI (Serial Peripheral Interface) settings or configurations.

SPI is a communication protocol used for transmitting data between microcontrollers and peripheral devices. It consists of a master device and one or more slave devices. The master device initiates the communication and controls the data transfer.

The "--clean" option in the "spi" command is used to reset or clear any existing SPI settings or configurations. This can include things like baud rates, clock modes, chip select pins, and any other parameters or configurations defined for the SPI communication.

By running "spi --clean", you can remove any previous configurations and start with a clean slate for configuring the SPI settings according to your requirements.

This explanation was created by an AI. In most cases those are correct. But please always be careful and never run a command you are not sure if it is safe.

back to the spi tool