
wpa_cli:ai:9eb6e
How to connect to a access point using wpa_cli command
$ wpa_cli -i ${interface} add_network
$ wpa_cli -i ${interface} set_network ${network_id} ssid '${ssid}'
$ wpa_cli -i ${interface} set_network ${network_id} psk '${password}'
$ wpa_cli -i ${interface} enable_network ${network_id}
$ wpa_cli -i ${interface} save_config
$ wpa_cli -i ${interface} set_network ${network_id} ssid '${ssid}'
$ wpa_cli -i ${interface} set_network ${network_id} psk '${password}'
$ wpa_cli -i ${interface} enable_network ${network_id}
$ wpa_cli -i ${interface} save_config
try on your machine
To connect to an access point using wpa_cli command, follow these steps:
- Add a new network using the 'add_network' command.
- Set the SSID of the network using the 'set_network' command with the '[network_id]' and '[ssid]' parameters.
- Set the password of the network using the 'set_network' command with the '[network_id]' and '[password]' parameters.
- Enable the network using the 'enable_network' command with the '[network_id]' parameter.
- Save the configuration using the 'save_config' command.
Replace '[interface]' with the name of your wireless interface, '[network_id]' with a unique network identifier (e.g., 0), '[ssid]' with the SSID of the access point, and '[password]' with the password of the access point.
This explanation was created by an AI. In most cases those are correct. But please always be careful and
never run a command you are not sure if it is safe.
Questions that are answered by this command:
- How to connect to a access point using wpa_cli command?