![Forrest logo](/images/logo.png)
hg-push:tldr:21615
hg-push: Specify a specific branch to push.
$ hg push --branch ${branch}
try on your machine
This command is using the Mercurial (hg) version control system to push changes from the local repository to a remote repository on a specific branch.
Here's a breakdown of the command:
- "hg push" is the basic command to push changes from the local repository to a remote repository.
- "--branch" is an option that specifies the branch on which the changes should be pushed. It is followed by "${branch}" which is a placeholder that indicates the actual branch name should be used.
- "${branch}" is a variable placeholder that needs to be replaced with the actual branch name you want to push the changes to.
So, when you run this command, it will push the changes from your local repository to the remote repository on the specified branch. Make sure to replace "${branch}" with the actual branch name you want to use.
This explanation was created by an AI. In most cases those are correct. But please always be careful and
never run a command you are not sure if it is safe.