back to the jmeter tool

jmeter:tldr:ed6f0

jmeter: Run a test plan in nongui mode using a specific proxy.

jmeter

$ jmeter --nongui --testfile ${filename}.jmx --proxyHost ${127-0-0-1} --proxyPort ${8888}

try on your machine

This command is using JMeter, a load testing tool, to run a test plan in non-GUI mode with a proxy configuration.

Here is the breakdown of each element in the command:

jmeter: The executable or command to run JMeter.
--nongui: It specifies that JMeter should be run in non-GUI mode, meaning it will run without a graphical user interface.
--testfile ${filename}.jmx: It specifies the test plan (.jmx file) that will be executed by JMeter. ${filename} is a placeholder that should be replaced with the actual file name without the .jmx extension.
--proxyHost ${127-0-0-1}: It configures the proxy host to 127.0.0.1, which is the loopback address or localhost. ${127-0-0-1} is not a valid variable name, and it should be replaced with the actual IP address or hostname of the proxy server.
--proxyPort ${8888}: It configures the proxy port to 8888. ${8888} is not a valid variable name, and it should be replaced with the actual port number that the proxy server is listening on.

In summary, this command runs a JMeter test plan in non-GUI mode using a specific test file and sets up a proxy with the specified host and port for capturing and recording network traffic during the test.

This explanation was created by an AI. In most cases those are correct. But please always be careful and never run a command you are not sure if it is safe.

back to the jmeter tool