opt:tldr:f00e4

opt: Run an optimization or analysis on a bitcode file.

$ opt -${passname} ${filename-bc} -S -o ${file_opt-bc}

try on your machine

The command you provided is written in a format that is often used in certain programming environments, such as LLVM (Low-Level Virtual Machine) or GCC (GNU Compiler Collection).

Here's the breakdown of the command:

opt is likely referring to the LLVM optimizer tool, which is used to perform various optimizations on LLVM Intermediate Representation (IR) code.
${passname} is a placeholder for a specific optimization pass or a sequence of optimization passes. Passes are individual optimization techniques applied to the code. For example, it could be "inline" for inlining functions or "mem2reg" for promoting memory operations to registers. The actual pass name should be provided in place of ${passname}.
${filename-bc} is another placeholder that represents the input filename with the ".bc" extension. The ".bc" extension typically indicates that the file contains LLVM IR code. You should replace ${filename-bc} with the actual name of the input file.
-S specifies that the output should be in human-readable LLVM assembly format rather than machine code.
-o ${file_opt-bc} specifies the output filename, again with the ".bc" extension. You should replace ${file_opt-bc} with the desired output filename.

When you run this command with the appropriate values filled in, it will pass the input file through the specified optimization pass(es) using the opt tool and generate the optimized LLVM IR code as the output file.

This explanation was created by an AI. In most cases those are correct. But please always be careful and never run a command you are not sure if it is safe.

back to the opt tool